Eizo CG210 Bedienungsanleitung PDF herunterladen (Seite 3)

Remote Director™ SWOP Application Data Sheet

Environment:

The room where Remote Director is installed must have controlled lighting. Room

lighting incident at the monitor and viewing booth plane MUST not exceed 30% and

SHOULD not exceed 10% of the dimmed booth brightness. The room walls should be

neutral gray and the room lighting should be D50 color with no direct entry of daylight.

Viewing:

Viewing angle is an important consideration when using Remote Director. The user

should only judge color when sitting directly in front of, and perpendicular to, the

display. The viewing station should be angled so that the viewer can make comparisons

without changing their viewing angle relative to the display.

The section ‘VIEWING INSTRUCTIONS’ explains how to compare a soft proof to a

hard copy proof.

VI. System Set-up:

1. Power up the G4, the EIZO CG210 display and viewing booth and allow at least

45 minutes for all components to warm up and stabilize.

2. Make sure there is no USB connection between the display and the computer

a. Press the ENTER button on the EIZO CG210 front panel and navigate by

pressing the right-arrow key twice to <Others>.

b. Press ENTER and navigate to the <Reset> function. Press ENTER and up-

arrow to select and press ENTER again to perform a display reset.

c. Press the right-arrow key once to <Return>, press ENTER

d. Press left-arrow twice to select <Color (Custom)>, press ENTER

e. Press ENTER again at <Brightness>, make sure it is set at 100%. Adjust if

required, press ENTER.

f. Press the right-arrow key once to get to <Temperature>. Press ENTER.

g. Press the right-arrow key until the temperature shows “Off”. Press

ENTER.

1 2 3 4 5 6 7

Keine Kommentare

Eizo CG210 Bedienungsanleitung Seite 3