Eizo FlexScan L461 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Monitore Eizo FlexScan L461 herunter. Eizo FlexScan L461 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken

Inhaltsverzeichnis

Seite 2 - CAUTION

10 1. INTRODUCTION1-3. Controls & ConnectorsFront(1) ScreenManager™(2) AUTO Adjustment button(3) Control Buttons(4) Enter Button(5) Power Switch(6

Seite 3 - TABLE OF CONTENTS

2. CABLE CONNECTION 11ENGLISH2. CABLE CONNECTION2-1. Before connectingBefore connecting your monitor to the PC, change the display screen settings (re

Seite 4 - PRECAUTIONS

12 2. CABLE CONNECTION2-2. Connecting the signal cable• Be sure that the power switches of both the PC and the monitor are OFF.1. Plug the signal cabl

Seite 5

2. CABLE CONNECTION 13ENGLISH2. Plug the power cord into the power connector on the rear of themonitor and plug the other end of the power cord into a

Seite 6

14 3. ScreenManager3. ScreenManager3-1. How to use the ScreenManagerAs shown on the display, the ScreenManager is used to adjust the LCD monitor.Scree

Seite 7 - CAUTION

3. ScreenManager 15ENGLISH3-2. ScreenManager Adjustments and Settings.The following table shows all the ScreenManager’s adjustment and setting menus.“

Seite 8 - 8 PRECAUTIONS

16 3. ScreenManager3-3. Useful FunctionsAdjustment LockUse the “Adjustment Lock” function to prevent any accidental changes.Locked function • Auto adj

Seite 9 - 1. INTRODUCTION

3. ScreenManager 17ENGLISHCP rotinoM DEL)H32~H1(doirePnOnoitarepOneerG"doirepnO"ni.nim51tsaLecitoNecnavdA1*gnihsalFneerGderipxe"doirepn

Seite 10 - 10 1. INTRODUCTION

18 4. ADJUSTMENT4. ADJUSTMENT4-1. Screen Adjustment• Allow the LCD monitor to stabilize for at least 20 minutes before making imageadjustments.Screen

Seite 11 - 2. CABLE CONNECTION

4. ADJUSTMENT 19ENGLISH3. Adjust by using “Screen” menu in the ScreenManager.(1) Vertical bars appear on the screen.ÆÆÆÆÆ Use the “Clock” p.35) adjust

Seite 12 - 12 2. CABLE CONNECTION

2SAFETY SYMBOLSThis manual uses the safety symbols below. They denote critical information. Pleaseread them carefully. WARNINGFailure to abide by

Seite 13 - WARNING

20 4. ADJUSTMENT(3) The screen position is incorrect.ÆÆÆÆÆ Use the “Position” adjustment.The correct displayed position of LCD monitor is decided beca

Seite 14 - 3. ScreenManager

4. ADJUSTMENT 21ENGLISH4. To set the Output signal range (Dynamic Range) of the signal.ÆÆÆÆÆ Use the “Range Adjustment”.p.36)This controls the level o

Seite 15

22 4. ADJUSTMENT 4-2. Displaying the low resolutionsThe lower resolutions are enlarged to full screen automatically. Using the “ScreenSize”function i

Seite 16 - 3-3. Useful Functions

4. ADJUSTMENT 23ENGLISH2. To be clear-cut the letters or lines of the enlarged screen.ÆÆÆÆÆ Switch the “Smoothing” setting.Select “Smoothing” in the s

Seite 17 - Off Timer

24 4. ADJUSTMENT4-3. Color AdjustmentThe “ColorManagement”menu in the ScreenManager enables to change the color of thescreen.Before the Color adjustme

Seite 18 - 4. ADJUSTMENT

4. ADJUSTMENT 25ENGLISH2. To change the saturation.ÆÆÆÆÆ Use the “Saturation” adjustment.The “Saturation” can be selected from -64 to 64. Setting the

Seite 19

26 4. ADJUSTMENTCP rotinoM DELnOnoitarepOneerGgnivasrewoPgnivasrewoPwolleYedomffOgnivasrewoP1*wolleygnihsalF)hcaerofsemit2(4-4. Power-save Setup• Do y

Seite 20 - 20 4. ADJUSTMENT

ENGLISH5. ATTACHING AN ARM STAND 275. ATTACHING AN ARM STANDM4 x 16 mm75 mm75 mmSoft Cloth orCushionThe L461 can be used with an arm stand by removing

Seite 21

28 5. ATTACHING AN ARM STAND3. Attach an arm stand to the L461 securely.For the Portrait display, rotate the monitor clockwise and use the software fo

Seite 22 - 22 4. ADJUSTMENT

6. TROUBLESHOOTING 29ENGLISH6. TROUBLESHOOTINGIf a problem persists even after applying the suggested remedies, contact an EIZOdealer. No picture prob

Seite 23

TABLE OF CONTENTS 3ENGLISHTABLE OF CONTENTS PRECAUTIONS ... 41. INTRODUCTIO

Seite 24 - 4-3. Color Adjustment

30 6. TROUBLESHOOTING Problems Points to check with possible solutions3. Display position isincorrect.4. Screen image is smalle

Seite 25 - 2. To change the saturation

6. TROUBLESHOOTING 31ENGLISH Problems Points to check with possible solutionsLeaving the screen white may solve the problem.“Sm

Seite 26 - 4-4. Power-save Setup

32 7. CLEANING7. CLEANINGPeriodic cleaning is recommended to keep the monitor looking new and to prolong itsoperation lifetime.• Never use thinner, be

Seite 27 - 5. ATTACHING AN ARM STAND

8. SPECIFICATIONS 33ENGLISH8. SPECIFICATIONSLCD Panel 41 cm (16.0 inch), TFT color LCD Panel with Anti-Glare Hard CoatingViewing Angle: Horizontal:

Seite 28

34 8. SPECIFICATIONSDimensions FRONT SIDE REARDefault SettingsDefault Settings are as follows: ScreenManager menu Default Settings Contr

Seite 29 - 6. TROUBLESHOOTING

9. GLOSSARY 35ENGLISH9. GLOSSARYAfterimageThe Afterimage is particular to LCD monitors when the monitor screen is left on fora long period without use

Seite 30 - 30 6. TROUBLESHOOTING

36 9. GLOSSARYPhaseThe phase adjustment decides the sampling timing point for converting the analoginput signal to a digital signal. Adjusting the ph

Seite 31

10. INDEX 37ENGLISH10.INDEXAADJUSTMENT --------------------------- 18Adjustment Lock ------------------------- 16Afterimage --------------------------

Seite 32 - 7. CLEANING

38 10. INDEXMEMO

Seite 33 - 8. SPECIFICATIONS

APPENDIX iAPPENDIXAPPENDIX / ANHANG / ANNEXEPreset Timing Chart for Analog inputTiming-Übersichten für Analog EingangSynchronisation des Signaux pour

Seite 34 - 34 8. SPECIFICATIONS

4 PRECAUTIONS PRECAUTIONS´ If the unit begins to emit smoke, smells like something is burning, ormakes strange noises, disconnect all power connection

Seite 35 - 9. GLOSSARY

ii APPENDIXMode Dot Clock Frequencies A: Front Porch B: Sync PeriodMHzHV HVHVkHz Hz µs/ ms/ µs/ ms/Dot Line Dot LineVGA 0.636/ 0.318/ 3.813/ 0.054/640

Seite 36 - 36 9. GLOSSARY

APPENDIX iiiAPPENDIXC: Back Porch D: Blanking Period E:Display Period F:Total CycleHV H V H V HVµs/ ms/ µs/ ms/ µs/ ms/ µs/ ms/Dot Line Dot Line Do

Seite 37 - 10.INDEX

iv APPENDIXMEMO

Seite 38 - 38 10. INDEX

Congratulations!You have just purchased a TCO’99 approved and labelledproduct! Your choice has provided you with a product developedfor professional u

Seite 39 - APPENDIX / ANHANG / ANNEXE

Environmental requirementsFlame retardantsFlame retardants are present in printed circuit boards, cables, wires, casings andhousings. Their purpose is

Seite 40 - APPENDIX

FCC Declaration of ConformityWe, the Responsible Party EIZO NANAO TECHNOLOGIES INC.5710 Warland Drive, Cypress, CA 90630Phone: 562 431 5011declare th

Seite 41

PRECAUTIONS 5ENGLISH• Keep small objects or liquids away from the unit.Small objects accidentally falling through the ventilation slots into the cabin

Seite 42

6 PRECAUTIONS´ Use the correct voltage.* The unit is designed for use with a specific voltage only. Connection toanother voltage than specified in th

Seite 43

PRECAUTIONS 7ENGLISH´ Handle with care when carrying the unit.Disconnect the power cord and cables when moving the unit. Moving the unitwith the cord

Seite 44

8 PRECAUTIONSSuggestions for Maximizing Comfort´ To lessen the chance of possible injury and to increase your comfort andproductivity while you operat

Seite 45 - Canadian Notice

ENGLISH1. INTRODUCTION 91. INTRODUCTIONThank you very much for choosing an EIZO Color Monitor.1-1. Features• 1280 x 1024 resolution p.36) incorporated

Kommentare zu diesen Handbüchern

Keine Kommentare