Eizo FlexScan SX3031W Bedienungsanleitung PDF herunterladen (Seite 5)

English

TroubleshootingSetting/AdjustmentPrior to use Installation

Connecting Cables

Attention

• When replacing the current monitor with a SX3031W-H monitor, be sure to change the PC settings for

resolution and vertical frequency to those which are available for the SX3031W-H monitor referring to the

resolution table (back of cover page) before connecting the PC.

Check that the monitor and the PC are powered off.

Connect the monitor to the PC with a signal cable that matches the connectors.

After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.

• When the resolution of the graphics board on your PC is applicable to 2560 × 1600 (Single display);

Connectors on the

DVI connector

Connectors on the

monitor

SIGNAL1

Signal cable DD200DL-BK (supplied)

• When the resolution of the graphics board on your PC is not applicable to 2560 × 1600 (Dual display);

Dual display (simultaneous left and right sides display) is available by using a dual DVI-D system graphics

board or any two graphics boards.

Dual display with 1280 × 1600 resolution is the maximum display size.

DVI connector SIGNAL1

Signal cable DD200DL-BK (supplied)

Connectors on the

monitor

DVI connector SIGNAL2

Signal cable FD-C39 (supplied)

Plug the power cord into a power outlet and the Power connector on the monitor.

1 2 3 4 5 6 7 8 9 10 ... 59 60

Keine Kommentare

Eizo FlexScan SX3031W Bedienungsanleitung Seite 5