Eizo FlexScan M1900 Bedienungsanleitung PDF herunterladen (Seite 8)

English

Prior to use Installation Setting/Adjustment Troubleshooting

No-Picture Problem

If no picture is displayed on the monitor even after the following remedial action is taken, contact your local dealer.

1. Check the Power indicator.

Symptom Status Possible cause and remedy

No picture Power indicator does not light

up.

Check whether the power cord is correctly

connected. If the problem persists, turn off the

monitor for a few minutes, and then turn it on

again.

Power indicator lights blue. Check the brightness setting.

Power indicator lights yellow.

Switch the input signal with

Press a key on the keyboard or click the mouse.

Turn on the PC.

2. Check the error message that remains on the screen for 40 seconds.

These messages appear when the input signal is incorrect even if the monitor is functioning.

Symptom Status Possible cause and remedy

The input signal is not received

correctly.

Check whether the PC is turned on.

Check whether the signal cable is properly

connected to the PC.

Switch the input signal with

The signal frequency is outside

the speciﬁ cation. Incorrect

signal frequency is shown in

red.

Change the mode to an appropriate mode using

the graphics board’s utility software. Refer to the

manual of the graphics board for details.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

Keine Kommentare

Eizo FlexScan M1900 Bedienungsanleitung Seite 8